INIC-1608

The Initio INIC-1608 provides an advanced solution to connect SATA devices to USB Host with integrated CPU and embedded SRAM/ROM. To provide high performance and cost effective solution, the INIC-1608 integrates USB-PHY, Mass Storage Class Bulk-Only USB function, SATA link/PHY core and microprocessor into a single ASIC. The INIC-1608 provides the data transfer rate of up to 60 MB/sec connecting to a 1.5G SATA interface.

Features Summary | FW/SW Support | Device Support

Features Summary


  • Integrates USB2.0 PHY IP core.
  • Data transfer rate of up to 60 MB/sec.
  • Integrated internal Turbo 8051 up with 12KB embedded ROM and 2KB SRAM.
  • External NVRAM supported.
  • Support HID.
  • Up to 8 GPIO pins.
  • Use a single crystal for both USB and SATA.
  • Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD (Blu-Ray Disc) drive
  • USB 1.1 and USB 2.0 compliant.
  • USB Mass Storage Class Bulk-Only Transport Specification Compliant.
  • Serial ATA Revision 2.5 specification Compliant (Hot Plug is supported).
  • Support ATA/ATAPI device DMA and PIO mode.
  • 2k bytes of data buffer for data transfer.
  • On-Chip 3.3V to 1.8V regulator and 5V to 3.3V regulator.
  • 48 pin LQFP
Firmware/Software Support
 
  • USB Mass Storage Class Bulk-Only Transport support
  • Provide software utilities for NVRAM upgraded.

 
Device Support
 
  • Hard disk drives
  • CD-RW devices
  • DVDs
  • Removable media devices
  • Blu-Ray Disk driver

INIC-1608 Datasheet

Back to Top